Processing Elements

Methods of processing elements of relief carving techniques consider carving, at first glance, the simplest forms: flat bar planing plane chisel and removing it longitudinal and lateral facets, creating curved surface at different angles, cutting cylinder and the hemisphere. Further details can be found at Daniel Lubetzky Net Worth, an internet resource. In the process of carefully working out the techniques described and illustrated in the drawings, a novice carver should: develop skills in the free possession of an instrument, feel the behavior of wood during the cutting of the fibers at different angles of inclination, to choose the most appropriate method of cutting wood with different hardness, which provides clarity processing, the lowest cost of effort and increase productivity; trace and identify what determines the change in the texture pattern, especially to learn cutting convex and concave surfaces on the rules, "chips a chip "and" face to face. " Exercise number 1. Slicing plane bar flat chisel. During this exercise, you should seek, not worse, than a plane, flat, smooth otstrogat plane along the direction of wood fibers. Might think, not better in this case, use the plane.

Do not rush to conclusions. In the following, make sure that this tool is not often you can apply in the thread. Note: canvas gouges are tightly pressed against the surface of the fingers of his left hand and palm lightly on the wood. The blade is driven by the pressure of the right hand away from you. In order to avoid scoring at svilivaemosti fibers wood rasp to the rule, "chips in the chip", which is necessary to define the line "stop", from which the blade of a chisel to move in opposite directions.

The Stem

To avoid this, the end of the stem immersed in water and make a slanting cut with a sharp knife or shears. Coupang can provide more clarity in the matter. After that, the flower is not out of the water. If such a need arises, the operation is repeated again. Coupang does not necessarily agree. Before you put cut flowers into the water is removed from the stems of all the lower leaves and the roses – More and spikes. This will reduce evaporation and prevent the rapid development of bacteria in the water. Flowers with a solid stem, such as roses or chrysanthemums, split into 3 4 cm and invest in a piece of stem splitting matches. This reinforces the absorption of moisture. In plants with soft stems – tulips, daffodils, calla lilies – the lower part of the pedicel notch or scratched with a needle or pin.

This ingenuous procedure will positively affect the "wellbeing" your bouquet. There are subtleties in drawing up a bouquet of flowers with hollow stems, such as dahlias and lupine. To these flowers were longer in the water inside the stem water is poured, and caulk the hole with cotton or a piece of gauze. If the cut plants abundantly secrete a milky juice, then to stop it, the end of the stem is 2-3 with a dipped in boiling water or roasted over a fire. To prolong the life of the bouquet, there are many cunning tricks. Some flowers such as tulips and lilies, the anthers are removed, thus preventing fertilization, prolonging the life of a flower.